Insulating paint

Basic parameters

Color Various colors

Proportioning single or two-component main agent: curing agent =25:5

Construction brush coating, spraying, rolling coating can be

The composition is composed of resin, insulating material, pigment filler, auxiliary agent, solvent, etc., and curing agent.

Product characteristics

High dielectric strength (breakdown strength). Insulating paint has a very high dielectric strength, usually greater than 10KV/m. This feature enables the insulating paint to effectively prevent current leakage in high pressure environments and ensure the safe operation of electrical equipment.

High volume resistivity. The volume resistivity of insulating paint is usually greater than 10Ωm at room temperature, which means that it is able to effectively resist current passing through, thus providing good insulation.

Chemical stability. Insulating paint has good chemical stability and can resist the erosion of various chemicals, including acids, bases and solvents. This enables the insulating paint to maintain its insulating properties in a variety of harsh environments.

Aging and corrosion resistance. Insulating paint also has excellent aging resistance and corrosion resistance, which can maintain the stability of its physical and chemical properties in long-term use and extend the service life of electrical equipment.

Construction parameters

Construction structure drawing:

Supporting scheme:

Insulating primer + insulating intermediate paint + insulating top paint

Construction notes:

The temperature of the substrate must be above the dew point of 3℃, when the temperature of the substrate is below 5℃, the paint film is not solidified, and it is not suitable for construction.

In the high temperature season construction, easy to occur dry spray, in order to avoid dry spray can be adjusted to dry spray until the diluent.

This product should be used by professional painting operators according to the product packaging or the instructions in this manual.

Steel surface:

Must thoroughly remove oil, rust, etc., to achieve the rust removal standard Sa2.5, the roughness of 30um-75um; Adopt manual rust removal method, need to reach the rust removal standard St3 level.

Concrete surface:

Concrete surface should be flat, dry, no seepage floating and water. The base that has been polluted by grease and chemicals can be washed with detergent, lye or solvent, and can also be treated by fire baking, steam blowing, etc., but it must not damage the base.

Precautions

Products should be stored in a cool and ventilated place to prevent rain, direct sunlight, avoid collision, need to isolate the fire source.

The construction site is strictly prohibited fireworks, painters should wear glasses, gloves, masks, etc., to avoid skin contact and inhalation of paint mist.

All work of coating and use of this product must be carried out in accordance with various relevant national health, safety and environmental protection regulations and standards.

If you have any questions about the use of this product, please contact our technical service department.